The Customer: Siskin Steel located in Chattanooga, TN. The Challenge: The customer has wheel problems on an overhead crane that impeded their ability to operate it, slowing down project completion times and halting their ability to…
The Excel team has been hard at work completing the complete build out and installation of 3 100’ span cranes for one of our great customers in two different locations they have. Two of these cranes have been installed into a new building expansion…
Excel Industries Inc. Was contracted by a customer that had been having extreme wheel wear problems. After doing a runway rail survey and checking the crane for square, Excel was able to determine the problem. After checking the crane, Excel found that the end trucks...
Excel Industries Inc. Was Contracted to Rebuild an Overhead Crane for Embraer Executive JetsAbout the Project Embraer requested Excel to inspect their two-year-old crane system to see why it would not travel up and down their runway. After inspecting the crane system,...
Excel Industries Inc. was contracted to build, and Install, a 10 ton, 50' span, single leg gantry crane with 40' high hook. All engineering was completed by Excel engineers, and built in house at Excel’s facility. The crane was installed by Excel’s installation crew,...
The Excel team is in the middle of wire up and testing of a 20-ton double girder crane. This crane is 100’ span and all fabrication of box girders are done in house. This crane is full VFD controls with Flux Vector hoist controls. This…
Design and build of 50 ton free standing runway, installation of runway and Demag crane. Excel Industries was contracted by a general construction company to design and build a 50 ton free standing runway for one of their customers. The complete runway system was...